TH-100A-HP provides continuous coverage from 3.4 to 28 MHz with the six foot whip.
This is without a doubt the best built, best looking, best performing, and highest power rating motorized antenna for its size and design on the market.
It has pre-installed sensors so you can add one of the auto controllers below.
All CNC machined antenna components are either aircraft aluminum or stainless steel and blue- printed - (you can take 100 antennas apart, mix them up and then reassemble them and they will all work the same!) Our coil form is 2 diameter and made of fiberglass. Other antenna builders know fiberglass is better but they choose not to use it because of the expense and difficulty in machining.
We use 14 gauge wire for high power capability wound at eight turns an inch for maximum efficiency. The decoupler is CNC machined for tight tolerances with custom fingerstock designed to contact three turns of coil all the time with over 25 pounds of combined contact pressure. You can run up to 1.5 kW PEP trouble-free.
TH-100A-HP comes with the Pittman 12 Volt commercial grade gear motor for the best performance. The motor is very durable and extremely quiet while receive tuning.
TH-100A-HP has a Lexan Weather Shield - this is the same stuff used on racecar windshields and even used to make bulletproof windows. It also uses the Powder Coat Paint System - And folks this is not spray paint in a can. You get a finish that looks as glossy and will last as long as the paint on a new vehicle.
That's just some of the effortthat goes into a Tarheel Antenna.
See the TH-100A-HPKG for the package deal!
|Lower Mast Length||3 ft.|
|Whip Length||6 ft.|
|Freq. Coverage w/ 6` whip||3.4 28 MHz|
|Power Rating||1.5 kW PEP|
|Typical SWR||1.5:1 or less|
|Collapsed Height w/ 6` whip||6 ft. 4 in.|
|Extended Height w/ 6` whip||11 ft.|
- Bar Code/EAN: