When properly installed on your vehicle the Model 200A-HP will provide continuous coverage from 3.4 to 28 MHz with the a 6' whip.
The Model 200A-HP comes with the sensors already pre-installed so if you decide to add one of the auto controllers (SDC-100 Simple Controller, SDC-102 Programmable Controller, Turbo Tuner, Antenna BOSS and BOSS II) now or later everything is ready.
The antennas CNC machined components are either aircraft aluminum or stainless steel and blueprinted, meaning you can take 100 antennas apart and mix up the parts then reassemble them and they all work the same. The coil form is approximately 2" in diameter and made of fiberglass.
The 200A HP uses 14 gauge wire for high power capability wound at eight turns an inch for maximum efficiency. The decoupler is CNC machined for tight tolerances with custom fingerstock designed to contact 3 turns of coil all the time with over 25 lbs. of combined contact pressure. With this design you can run up to 1.5 Kw P.E.P trouble free.
This antenna also comes with the Pittman 12 volt commercial grade gear motor for the best performance. It is very durable and very quiet while receive tuning. The weather shield is made of LexanTM. This is the same stuff used on racecar windshields and even used to make bulletproof windows.
The antenna is a plug & play system. Included is the antenna. manual switch box, 20 ft. of control cable, ferrite decoupling core, base matching coil, 3/8-24 stud, connectors, fuseholder and fuse.
- Lower Mast Length: 4 ft
- Frequency Coverage with 6ft. whip 3.4 to 28 MHz
- Power Rating 1.5 Kw P.E.P.
- Typical SWR 1.5 to 1 or less
- Total Height with 6ft. whip at 28 MHz 10'4"
- Total Height with 6ft. whip at 3.4 MHz 12'
- Weight: 8.5 lbs.
- Bar Code/EAN: